STANDBY 1000 ekW 1250 kVA
60 Hz 1800 rpm 480 Volts
FACTORY INSTALLED STANDARD & OPTIONAL EQUIPMENT
System Standard Optional
Air Inlet • Single element canister type air cleaner
• Service indicator
• Dual element air cleaners
• Air inlet adapters
Cooling • Radiator with guard (43ºC)
• Low profile (frontal area)
• Low airflow
• Coolant drain line with valve
• Fan and belt guards
• Caterpillar Extended Life Coolant
• Coolant level sensors
• Radiator duct flange
• Radiator with 27ºC ambient capability
• Jacket water heater
Exhaust • Dry exhaust manifold
• Flanged faced outlets
• Stainless steel exhaust flex fittings
• Elbows, flanges, expanders & Y adapters
Fuel • Primary fuel filter with water separator
• Secondary fuel filter
• Fuel priming pump
• Flexible fuel lines
• Fuel cooler
Generators • Class H insulation
• Class F temperature (105ºC prime/130ºC standby)
• Winding temperature detectors (select models)
• Anti-condensation space heaters
• Oversize & premium generators
Power Termination • Bus bar (NEMA and IEC mechanical lug holes) -right
side standard
• Bottom cable entry
• Circuit breakers, UL listed, 3 pole with shunt trip,100%
rated, choice of trip units, manual or electrically
operated (low voltage only)
• Circuit breakers, IEC compliant, 3 or 4 pole with shunt
trip (low voltage only), choice of trip units, manual or
electrically operated
• Shroud cover for bottom cable entry
• Power terminations can be located on the left and/or
rear as an option. Also, multiple circuit breakers can
be ordered (up to 2)
• Top cable entry
Governor • ADEM™ A4 • Load Share Module
Control Panels • EMCP 3.1
• User Interface panel (UIP) - rear mount
• Emergency Stop Push button
• EMCP 3.2 and EMCP 3.3
• Right or left mount UIP
• Local & remote annunciator modules
• Discrete I/0 Module
• Generator temperature monitoring & protection
• Load share module
Lube • Lubricating oil and filter
• Oil drain line with valves
• Fumes disposal
• Gear type lube oil pump
• Deep sump oil pan
Mounting • Formed steel welded base
• Anti-vibration mounts (shipped loose)
Starting/Charging • 24 volt starting motor(s)
• Batteries with rack and cables
• Battery disconnect
• Battery chargers (10 Amp)
• 45 amp charging alternator
• Oversize batteries
• Ether starting aid
General • Right-hand service
• Paint - Caterpillar Yellow (except rails and radiators
that are gloss black)
• SAE standard rotation
• Flywheel and Flywheel housing - SAE No. 0
• UL 2200
• CSA certification
• EU Declaration of Incorporation
• EEC Declaration of Conformity
September 02 2009 14:28 PM
2
SS-006378.pdf: Secured on 09/03/2009 02:17
Comments to this Manuals